This is the nicest Knock-Down furniture I've ever assembled. With that said, don't let the following remarks dissuade you; they are meant only to help as "heads-up" tips in assembly. Yes, it is all solid wood. My only complaint is the cam-lock system, specifically the cams are pretty cheap pot metal. Be sure the mating pins are perfectly perpendicular to the board and don't "bury" the pins past their "stop flanges".Kudos to the manufactures as they give you several extras, just in case. If the cams don't turn with moderate force, double check the pin position or you will deform the cam.As for the color debate in the reviews, I bought the "honey brown" model. The color is just slightly a half-shade darker than the Amazon pic: think: Golden > Antique Oak in color. Mine is nowhere close to walnut as some have guessed.Do yourself a HUGE favor and use a 1/4" drive ratchet with a 4mm allen head bit when attaching the top panel to the sides and interior partitions; there is almost no clearance to turn the provided allen wrench. It is tempting to screw the door hinges on the cabinet rather than putting them on the door first...DON'T. This type of Euro-hinge swings forward so the back of the door doesn't pinch on the cabinet side. Save yourself a lot of grief and mount them on the doors first. Also, the hinges adjust on all 3 axis; up and down to center the door vertically, in and out to "tip" the door in and out and in and out to "tip" the door side ways (think: rotate).The hinge plate that goes on the cabinet has two slotted hole and two round holes.Place your screws in the center of the slotted holes first, then you can check to see if the doors are the same height off the bottom of the cabinet. Adjust them until they are THEN go back and put the remaining screws in the round holes to secure the final adjustment. All the holes for the hinges and latches are not pre-drilled and may be just light "dimples". place your hardware over them and pre-drill or use an awl to mark them prior to mounting doors. As others have mentioned, the back panel is not drilled out for all of the perimeter screws. Try-fit the panels to be sure they center on the edges and over the center interior panels and pre-drill the panel and the board your screwing into. Note: all the holes in the middle areas are "half-holes". The head of the screw at those points spans where the panels butt together and "sandwiches both edges in place. Again, kudos to the manf. as they give you plenty of screws for this task.Finally, my biggest beef is the cabinet pulls. The cheezy brushed chrome finish does not say, Shaker style to me. I went to Lowes and for around $20, picked up some bronze pulls that look way better in my opinion.Yes, have a helper or hand truck when you receive the parcel it is HEAVY! BTW- the shipping was super fast, received it in two days w/o Prime!!This is a dang nice cabinet!! Supports my 55" LED TV without so much as a wiggle.